DIY Home Improvement Forum banner
Cancel

Search Results for ‘output’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs stucco subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall walls water water heater window windows wire wiring wood
  1. Plumbing
    This is a long story...and no, it's not about a problem with the sump pump. The house was built with the basement below the water table, so the sump pump has to work continuously to keep the water out. The house sits on a low spot in the area where the houses behind it (for blocks and blocks)...
    check valve output sump pump water
  2. Electrical
    I replaced the ballast and wired it blue-blue, red-red, blk-blk, wht-wht. I didn't realize that the new ballast wires in paralell, the old was in series. 2 blues on one end and red on the other with black and white as line. It did work for a while, but now nothing. Did I fry the ballast? Can I...
    ballast fry output test
1-2 of 2 Results
Top