DIY Home Improvement Forum banner
neutral bar
1-9 of 9 Results
  1. Electrical
    Hello all, I opened my panel recently to replace my buzzing doorbell transformer. I’ve been putting it off for ages. It has been buzzing for the past 25 years or so, so I figured it was time to get to work. So I purchased the replacement and then… (I am located in Alberta, Canada) Upon...
  2. Electrical
    I have two separate dedicated circuits with their respective ground and neutral wires tapped under the same lug on the bus. (See images: first is easy to spot on top terminal. Other is the third lug from the bottom.) One on each neutral bar and both are dedicated 15 amp to outside lights; a...
  3. Electrical
    While adding a sub-panel I found I have no remaining space on the neutral bar for a 3/0 neutral connector. Is it acceptable to "split bolt connect" my 3/0 sub-panel neutral directly to the SE neutral in the main panel? (to the yellow highlighted spot in picture) -Main Service Feed is 2/0 SE...
  4. Electrical
    The neutral bar in my control center has 2 screws that are stuck and are unusable. If an electrician can't unscrew them and render them usable can the entire bar be replaced?
  5. Electrical
    Looking inside the electrical panel in the house I bought, I was surprised to see the neutral bus bar crowded right up next to the ground bus bar, so much so that it seems the ground bus bar is virtually impossible to access in order to secure grounding wires to it. Here's a photo: The...
  6. Electrical
    I have a Square D panel. It has two bars where neutral wires can be connected. Does it matter which connection bar to use for given neutral wire coming into the panel? Thanks
  7. Electrical
    Is it ok to swap out the bottom bus bar to one that has there large lugs on it? I have a 50amp breaker already on that side I added that I need to make a run from to outside. The large lugs on the top bar are already being used. I want a bar on the bottom just like the one on top
  8. Electrical
    I am sure there have been many reported wirings of old houses. I am gradually rewiring an old house (log cabin). I think the original wiring must have been done by the seat-of-the-pants of whoever was doing the wiring -- different people at different times. Most of the circuits are two-wire...
  9. Electrical
    Hey Everyone, Thanks for taking the time to read my post. I am wiring a new room in the basement. In doing so I am adding three new AFCI circuit breakers to my box. As I have read other folks mention... I am low on spots on the ground bar. Just some quick info on my what I have: Breaker...
1-9 of 9 Results
Top