DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Electrical
    I have a Leviton motion sensor switch I want to use. The switch in my garage is a rocker light switch, not one of the older ones. It goes to a fluorescent light with the long light tubes, not a regular bulb light fixture. Is there a reason why it wouldn't be changeable to the motion sensor? I...
  2. Electrical
    Greetings everyone. I have an issue that I can't seem to find an explanation for anywhere. I've looked all over the net, and all over this forum and can't locate a similar concern. Here it is: I have a 2 socket motion detector outdoor fixture on my garage, works great but the bulbs burned...
  3. Electrical
    Looking for help on my project. See image. Testing before connecting to high voltage device. This is my first attempt using a relay. Using a 3v relay triiggered by the PIR signal. As you see wired now, There is no ground wire coming from PIR only Red + and Yellow signal to relay.. The...
  4. Electrical
    Hi all. just a quick question for you. I've been replacing all my mother and fathers light switches with new motion sensor switches. These are great, but I've come across a small issue with them. Most likely just my OCD kicking in hard core, but I have 120V AC on the LINE line, and when switched...
  5. Electrical
    Hi Everyone, My first post here! Looks like there is a lot of great information out there, if this has already been covered than I apologize. I'm looking to install an outdoor flood motion light in the backyard. I live in a one story ranch with basement (if that helps) and accessible attic...
  6. Electrical
    Im installing motion detector lights... the only thing is i want them switch activated too, so that the motion works and I can turn them on also. Which type of wire should I use? Any ideas?
1-6 of 6 Results