DIY Home Improvement Forum banner
maytag
1-18 of 18 Results
  1. Appliances
    Hello, looking to confirm that this drip might likely be caused by the tub seal gasket? Are there any other seals we should look at replacing? Drips are coming once every 5 seconds or so, more quickly when the load is full. (Red circle around a single drop of water from a video freeze frame.)...
  2. Appliances
    Good Morning All! I am in need of replacing a cheaply made BRADA top load 'HE' washer. My two options are for a used older Maytag belt drive A506 or a direct drive Kitchen Aid. Which should I go for?
  3. Appliances
    Hello everyone .. I am new here and found your site while looking for a solution to my current problem. I have a Maytag Quiet Series 300 Dishwasher - MDBH955AWB that is stuck in rinse only mode. I have searched the internet and tried the following: Disconnected power for 1 minute (no fix)...
  4. Appliances
    My Maytag Centennial washer was making a hideous noise sometimes while agitating, especially during the rinse cycle. It also had a weird plastic sawdust smell. I troubleshot the problem and the pulley wheel was rubbing on the cover. In addition, evidently a cork got stuck in there and it was...
  5. Appliances
    Hello, I have a Maytag oven, mgr5750adw. The oven hasn't been working properly so we called the gas company to take a look at it, since they were the last ones to touch it and it has been faulty since they messed with it. They quoted me $400 to replace the igniter and the safety valve. The...
  6. Appliances
    I have a Maytag fridge (MBF2258DEM) and the ice maker is not working. I replaced the ice maker with a different old ice maker that I had lying around and that wasn't working either. I also installed a new replacement ice maker that I purchased, still not working. (same model that comes with...
  7. Electrical
    I just got a Maytag model N: MDE6200AYW Which came with a 4 foot 3 prong power cord, too short to reach my dryer power outlet. I was going to get the 3 prong 6 foot cord and just connect it to the dryers terminal, which has two hots connected on either side, which a netruel in the middle..which...
  8. Appliances
    Model #MVWC200XW3 MAYTAG It is filling water correctly. The cycles are all messed up though. It just keeps agitating, spinning. Rinse and spin and drain and spin are no longer that, instead it fills with water and washes.
  9. Appliances
    I have an old Maytag washer, model LAT9700AAL. Came with my house when I bought it 6yrs ago. Yesterday, washer filled with water and stopped. No timer advancing, no motor running. Crickets. When I manually advance the timer, the washer will drain, spin, and advance to rinse. At rinse, it fills...
  10. Appliances
    Hey guys, So, I've decided to try to trouble shoot and fix this unit myself. Problem: Refrigerator and Freezer are not getting cold (Maytag MBF1956HES) - The lights and fans are working fine. What I've done so far: I checked the Start / Overload relay and it was rattling. I took it...
  11. Appliances
    never ending washing machine cycle Old Maytag, I didn't see any model information, it just says: 2 Speed - Large Capacity. I didn't really feel like pulling the thing out from the wall to check the back for information. Looks like it might be original to the house, late 60's. It started...
  12. Electrical
    Hello, I have read a lot about this topic here, but it appears I may have a somewhat unique dryer (it is a Maytag so probably not). My main concern is that when there was a four prong plug installed in the dryer, the green prong and a white prong that is part of a cable bundle heading back...
  13. Appliances
    I have a Maytag dishwasher, model number DWU8460AAX, that leaks like crazy from the air inlet in the drain pan. The leak only occurs during the actual wash or rinse cycle, not during any other time. This website shows the blower assembly...
  14. Appliances
    My Maytag 5000AWW won't fill (with the lid open or closed), and won't start at all (no spin, rinse, etc.). I've checked that the outlet it's plugged into is working, and I've checked that the water supply is on, and that water is coming out of both hoses, etc.. It seems like the machine is dead...
  15. Appliances
    Maytag model msd2651hew side x side water dispenser continuously dripping. Changed filter and it stopped for about three weeks. When I place finger over spout it builds pressure, when release it lets out backed up water and continues to drip. I need help to diagnose this challenge.:(
  16. Plumbing
    Just bought a stainless Maytag DW, and while reading the install manual, is says to use a 3/8" N.P.T. elbow to connect to the water inlet valve. It also shows the inlet having a female recepticle in the illustration. When I flipped the DW on its back and looked at the valve, the threads are blue...
  17. Appliances
    On my Maytag LAT9700 washer (with the front panel off and the chassis-top lifted), during fill, the aerator tube leaks substantially. The washer is about 12 years old. The aerator tube (I have seen it called an "air gap fill injector tube") is located in the fill line about 9 inches before the...
  18. Appliances
    Got a Maytag Legacy Series top load washer (SAV205DAWW) that is extremely loud when in the spin cycle. All else is good, but it sounds like a "dry bearing" rolling. Not sure if the bearing can be changed, nor how to get to it if it can be. I am pretty handy with this kind of stuff, any words...
1-18 of 18 Results
Top