DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. HVAC
    I have a Luxaire gf8050b12mu11a furnace that gave me a 7 red flash (failure to establish flame/no light condition) error on Christmas Eve. We cleaned the flame sensor and she fired right up. Last weekend it happened again so I cleaned the flame sensor and we were back in business for about 24...
  2. HVAC
    I'm having an issue with my Luxaire TG9S080B12MP11A. It tries to light three times then blows cold air for minutes. I can reset it with the thermostat and it tries again, sometimes lighting. Looking at it I get 7 Red flashes and see only two of the four burners start to glow when it tries to...
  3. HVAC
    I have a Luxaire AC unit in the attic and repeatedly have had the condensate pan fill up, which triggers the safety float and stops the unit from running. We've rarely even used AC this year because we've had a cool summer in the NE. I previously paid a repairman to fix this issue and evidently...
  4. HVAC
    I have a Luxaire model # PBNULD10N0600 When my thermostat is calling for heat, it doesn't kick on. The solution so far I have found is, to take cover off bottom panel, hold in the panel switch, tap on the box which I assume is all the relays, etc. And it will kick on every time. Was going to...
  5. HVAC
    Fellow DIY's: I have an 18 yr old Luxaire PBNU-LD10P060A HiEff LP furnace that started acting up this winter. The local serviceman has not been able to fix. I think that 3R (Ventor Fan Relay) has a bad/intermittent coil and I have ordered a replacement. I have a question for you experts out...
1-5 of 5 Results
Top