DIY Home Improvement Forum banner
help
1-7 of 7 Results
  1. Roofing/Siding
    Hey All, My house is a cape cod, where the attic/ has been finished into 2 bedrooms and a bath. Had the roof replaced a couple months back(mid march), the previous roof(setup?) had gable end vents nothing at the roof line and no ridge vent. it was definitely warmer in the summer than the lower...
  2. Electrical
    Hello, Pretty sure I’m missing something stupid obvious but here goes. I want to cover this junction box with a plastic, blank cover, but none will fit. As you can see in the pic, the screw holes are in the corners. Also this is not flush with the wall but rather set back the depth of the...
  3. Appliances
    The title basically covers it. My sister (a single mother of two) finally found a house and had movers move the house. They waited until they moved the chest freezer to unplug it, still full of food, and moved it to the new house, in the basement. They didn't tip the freezer but it was bumped...
  4. Automotive Repairs
    Hi everyone. A kid on a bicycle broke my side mirror. Everything on the mirror still works (the mirror moves with the button, the camera works, the sensor, the light, etc). But the piece where it connects to the car and swivels is broken. The local auto body shop and the dealer quoted me...
  5. Plumbing
    I've purchased an older house to fix up and rent, and repairs have been going really well so far. Everything was in working order, and I am simply upgrading certain aspects to make it better. However, overnight, the water pressure to the bath has slowed to a trickle. Pressure is great everywhere...
  6. Painting
    Please help me decide on paint color(s) for my house - above photo - NO brick painting, no garage door painting. May or may not paint the shutters. Prefer to use colors by Sherwin Williams. All ideas welcome.
  7. Building & Construction
    for instance, let's say i want to make a hole in the wall 1 foot from the floor and 3 feet away from the end of the wall? for example yesterday i was drilling holes to hang some blinds. i needed to drill the holes 4" from the edge of the trim and 0.5" in. i used a tape measure to get both...
1-7 of 7 Results
Top