DIY Home Improvement Forum banner
Cancel

Search Results for ‘halo’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting masonry mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Electrical
    I just installed two lutron sunnata dimmers and a new halo canless night light. The 3 way switch was originally there so I expanded the bay to have a second single pole switch. I combined the grounds from the 3 way, the new light, and the power coming into the box and created branches for each...
    3 way dimmer switch dimmable halo light switch lutron
  2. Electrical
    http://dl.dropbox.com/u/15945493/Photo%202012-04-03%201%2017%2041%20PM.jpg Hi all, I'm replacing the regular bulb with a halogen but I don't see any tabs or clips for the housing to stay in place inside the HALO. Am I missing something? Thanks for the advice
    halo pot light
  3. Electrical
    I am installing 4" HALO Airtite cans in toilet/shower area using new construction cans and one area of ceiling is 5/8 sheetrock and the shower stall will have 5/8" plus thickness of tile on ceiling. The ring that extends down from the HALO can is only 1/2" (I assume for 1/2" sheetrock) so I am...
    halo sealing sheetrock shower tile
1-3 of 3 Results
Top