DIY Home Improvement Forum banner
ground fault
1-4 of 4 Results
  1. Electrical
    I have a GFCI that wont reset. I did the following. 1. Replaced it, but still trips 2. Removed the load receptacles, but still trips 3. Checked voltage from hot to neutral. 118 4. checked Voltage from hot to ground. 118 5 turned circuit off at breaker box and check for continuity. 6. no...
  2. Electrical
    I have searched quite a bit on this and have come up empty. Hope someone here can help. We are finishing a basement and we have wired the bedroom and bathroom lights on the same circuit. Bedroom lights need AFCI and bathroom lights need a GFCI if they are above a bath or shower, which they are...
  3. HVAC
    Recently bought a replacement control board for my 14 year old York furnance. The replacement part number is 21-33102956000. I am getting a repeating "nine red blinks" on the LED error indicator. Tha means polarity or grounding problem. My old board grounded through a screw that connected the...
  4. Electrical
    Hi, I have a new propane gas furnace installation (we converted from oil). Everything seemed fine, except that the ground fault tripped in a bathroom, they tried the air conditioning, but it will run for a few seconds and then stop and at this time the furnace will turn on. They could not...
1-4 of 4 Results
Top