DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 19 Results
  1. Appliances
    I took out the second to bottom drawer (veggie drawer) on our Kenmore Elite fridge to clean it. The drawer attaches to a top plastic piece which has a removable piece of tempered glass. The plastic top where the drawer slides in and out of is supposed to sit down on two protruding knobs. When I...
  2. Appliances
    We bought a new standard size standing fridge, just a fridge. But even with it full with food I can't seem to stop it from sliding or jiggling on our tiled floor. I know this isn't good for the fridges life span so I need to know what type of mat should I invest my money in to prevent it from...
  3. Appliances
    Inside the door of my refrigerator (a top freezer model), the plastic surface just above the shelves is constantly wet these days. My house is air conditioned and my inside humidity is under control. Yet the inside of the door has a lot of condensation all of the time. The fridge is an...
  4. Appliances
    Not sure this is the right place. Our fridge started to cool less over the last few days. There is a clicking sound but neither the compressor or fan seems to be running. Tested both, as well as the starter relay with a multimeter, all compenents are fine and give appropriate readings.The coils...
  5. General DIY Discussions
    I bought a scratch n dent refrigerater. Apparently the handle on the freezer had been bumped hard. One day the handle broke. I noticed that the hole where the screw holds the handle on was damaged. I got a new handle, but if i put the screw in, it is going in at an angle. I'm afraid the new...
  6. Appliances
    Howdy, its been a while since I posted in the forum. :) My question is pretty straightforward and is told in this thread's title. The reason of such is I'm about to phase out my former trusty refrigerator as it has reached its lifespan already (more than 15 years). However before doing so I'd...
  7. Appliances
    I'm doing a small kitchen reno - my space for my fridge measures at 35.75" - I have a large family and want the biggest french door fridge I can get in there. Anyone ever here of a 35" fridge?? Any makes or models that are bigger than 33" and smaller than 36"??
  8. Appliances
    I have a Frigidaire FFHS2612LS7. Two days ago the water stopped working through the door.The water isn't making it to the ice maker either, but the ice maker motor is still operational when the lever is depressed. I checked the line leading into the back of the fridge. the water is entering...
  9. Appliances
    I'm having a new (French door) fridge delivered this week. Depth with doors removed is 32 7/8". Opening in the kitchen door is 32 3/8". There's another way in, but the fridge would have to be carried in on its side to clear the counter. I know that putting a fridge horizontal is not a good idea...
  10. Appliances
    Our "new" home has a GE Monogram refrigerator model ZICS36NALH, which was put in place in 2001 by the builder of the house. In other words, it is at least 14 years old. It's been working fine until these days' heat wave, and now the freezer won't freeze. If repair isn't possible or costs too...
  11. General DIY Discussions
    I have a guy coming into to do this for me, One thing is concerning me though, obviously with these type of fridges you need to tap into a drinking water supply, however; the guy who is doing it said he was going to tap into the boilers cold water feed pipe and run all the pipe work into thw...
  12. Appliances
    Is it ok to put a dorm size fridge in a wall? It is this model: http://www.amazon.com/Sanyo-SR-2570M-2-5-Cubic-Foot-Refrigerator-Platinum/dp/B00006JKZO/ref=cm_cr_pr_product_top/180-0863213-0203945 If so How many inches in the back should there be of air space? Thank you.
  13. Appliances
    Hi, I just got a new Whirlpool refrigerator, and to get water to it, I tapped into the cold water line for my washer, using a self tapping set up. The pressure is very very low....AND now my whirlpool washer won't fill during the rinse cycle. Any thoughts?
  14. Plumbing
    Hey all! I want to install the ice maker kit in our freezer. Problem is I have no plumbing going to the refrigerator. The run seems easy enough, about 18 feet from the sink to the top of the refrigerator. The ice maker hookup is at the top of the fridge. The question I have is how to go...
  15. Appliances
    I have a GE side by side (GSS20GEW) and I am having the ice machine freeze and build up at the top where the water inlet tube is, above the freeze tray, and then leaking into the back of the freezer interfering with the fan, it seems to be putting out too much water, on outside of the ice...
  16. Appliances
    I am a newbie DIY-selfer and searched for this kind of issue on this forum. The others who had a similar issue had freezer that continued to work fine. Mine seems to not, so I am posting the question. I have a Kenmore/Sears refrigerator with a bottom freezer (fridge compartment is on top)...
  17. Appliances
    Hey Guys, I've got a leak where the water lines connects with my fridge. When the valve is opened water sprays from the leak location that I signified in the picture. There are two pictures of the part that the water line hooks up to. Any help is appreciated.
  18. Electrical
    I have a Whirlpool side by side fridge freezer which developed a problem whereby the lights on the control panel started to flicker and the water from the dispenser started to pulse as it came out. Tried turning it off and on but to no avail. It has now subsequently packed in and does not come...
  19. Appliances
    So I'm not sure if there's a problem here, but within the past few months, the fridge in my new house (first time home buyer) started making VERY odd noises - it sounded a little possessed, like it was thinking about something and making different pitched mechanical noises (I really can't...
1-19 of 19 Results
Top