DIY Home Improvement Forum banner

floor leveler

  1. Tiling, ceramics, marble
    I realized while using a laser level for wallboard install that I have a low and a high spot in one corner of a large bath (11'x15') near where a large slipper tub will sit. The low spot is about 3/16" lower than the outer edge of the room and that edge at the corner is about 1/8" higher than...
  2. Flooring
    I was going to caulk the edges of my vinyl bathroom floor and found a water damage disaster instead. This is an old Victorian and the original floor is wood slats about 2 inches wide with a small gap between each slat. What I found is that there are 2 layers of vinyl and there is moisture...
Top