DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. HVAC
    My 5-year old high-efficiency ICP furnace won't stay lit with the burner panel on. With the panel on, I look through the little window, and the last burner (where the flame sensor is) flickers and then goes out after 30-60 seconds. The fan keeps going and it cycles through that way a few times...
  2. HVAC
    Events to date: *Resolved possible drainage issue *Replaced filtrete filter with low resistance permanent filter (about 5 days ago). **These resulted in unit working fine for about 5 days, but issues starteed again today. *Have cycled the furnace about 5 times today. Previously, only saw code...
  3. HVAC
    I have a used 50 gallon Rheem "Fury" series water heater (built in 2005) that I just installed, but we can't seem to light the pilot flame. We hooked up the gas line and turned on the gas. Then we turned the dial to "pilot", held down the pilot-gas button, and depressed the "Piezo igntion...
1-3 of 3 Results