DIY Home Improvement Forum banner

feeder cable

  1. Subpanel feeder wire run briefly between concrete and floor?

    Electrical
    Without going into great detail, I am going to be running a 6/3 feeder wire through a few joists in my basement ceiling and up a wall shared with the attached garage. I have a unique situation in that there is a 'bump out' front entry closet that sticks into the garage a couple feet. It sits on...
  2. Fedder for 100A subpanel 100' from main

    Electrical
    I majored in sociology, so please bear with me... I am building a 400 sq ft out building with 2 1500 watt heaters, a small kitchen including a small range, small dishwasher and fan hood. There will also be a 30 gal hot water tank, and a .1/2 hp sewage ejection pump. My calculations so far...
  3. What feeder wire should I use for 200amp service @ 220 feet in 3" conduit?

    Electrical
    I was told 350,350,4/0 Any ideas, thanks
  4. 4/0 wire issues

    Electrical
    I am running a 125 amp sub off my main panel and have used 4/0 AL, however, I am now having issues with the wire not fitting into the lugs in the 125 amp panel. I have not been able to find replacement lugs, so am looking for advice. One electrician I talked to said to "trim" them down to...
Top