DIY Home Improvement Forum banner
ecobee
1-10 of 10 Results
  1. HVAC
    Hi, I am trying to install my Ecobee smart thermostat in place of my old one. My current setup is HRV: Air Exchangers: Constructo 1.5 ES HRV So, as per the installation guideline https://www.venmar.ca/DATA/DOCUMENT/1477_5_en~v~installation-manual.pdf I have an alternate furnace interlock...
  2. HVAC
    So, we finally got around to running new wire from the thermostat to the furnace. We're installing an Ecobee4, which requires a common wire, but we decided on running new 5-wire cable, just in case. Anyways, there's no labels on my furnace and we have no idea how to connect the new wiring. I...
  3. HVAC
    Hello All, I'm trying to prepare to install my Aprilaire 700M. I'm trying to wire it the same way as the attached picture in color from the Amazon review to work with my Ecobee 4. However, my setup has a zone controller where I have two thermostats connected to the zone controller that can...
  4. HVAC
    Hey everyone, just installed a Honeywell 360A humidifier last night but have not powered it on yet. I need to get a 3/4" drill bit to get the pressure switch installed. My question is do I really need it? My understanding is that the pressure switch is used to verify that the furnace is actually...
  5. HVAC
    I have a CARRIER 59TN6A060V17-14 60000 BTU, UP TO 96% AFUE, MULTI-POSITION, TWO STAGE, VARIABLE SPEED GAS FURNACE controlled by an ECOBEE 4 2-stage thermostat. There is no air conditioning unit, but one may possibly be installed in the future. The ECOBEE 4 replaced a Pro1 T705 1-stage...
  6. HVAC
    If anyone can look at this diagram and let me know how I can connect my "C" (Blue) unused wire to get my ecobee working is appreciated. I tried connecting the "BLUE" to the "C" (while red and white) is already there connected from the A/C and that burned my fuse (3 amp), ended up replacing it...
  7. HVAC
    I have a g6RC080-16 (no manual anywhere online). I use an ecobee3 thermostat and installed it with 5 wire to my hvac. No big deal. Then I installed a new whole house humidifier since the guy said the solenoid was bad. Installed everything up in a 2-wire install and still no water coming out...
  8. HVAC
    Hello, I just bought an ecobee3 thermostat for my condo that I am renting. It previously had a Venstar T2800 Thermostat. I have a FHP Bosch EC024- Unit, and I believe it’s a geothermal since there is water connections going in and out and that’s seems to be what I found after doing some...
  9. HVAC
    Ok I have a HVAC unit and I am replacing the t-stat. Here are the current wire hookups and there discription on the old t-stat (Robertshaw 9420). C-Blue ~24v Com R-Red ~24v Transformer Y1-Yellow ~Compresser Relay (Stage 1) E-Black ~Emerg Heat W2-White ~Aux Heat Relay (Stage 2) G-Green...
  10. HVAC
    I have recently had two HVAC techs install a completely new HVAC system and a new Ecobee Si. One of the guys wired the outside HP and one wired the indoor AH. I know that they had several of the wires wrong because I have checked them ex: the B terminal at the HP was attached to a blue wire...
1-10 of 10 Results
Top