DIY Home Improvement Forum banner

diagram

  1. Electrical
    Hello - I was wondering if someone out there would be able to advise on the correct connections I need to make in order for the three lights in the attached diagram to operate independently via the three switches also depicted in the diagram. A 14/2 wire from a 15 amp breaker is feeding power to...
  2. Electrical
    Hello all First I'm not a pro, I do and will make mistakes, and this may be my first one on the forum...:wink2: Nevertheless, I'm building a pergola, and I'm having a doubt concerning my wiring... This built is "officially permitted" and I will have an electrical inspection later...
  3. Appliances
    Hello there. Looking for help with wiring in a temperature control (mechanical thermostat). Have pictures and will post.
  4. Plumbing
    I live in New York state and had a Rinnai RU80i tankless water heater installed in the basement of my house. I am doing the plumbing for the cold and hot water pipes and wanted to get some feedback on if I designed the system correctly (a diagram is attached--larger PDF too). There are fixtures...
  5. Electrical
    I have this car alarm that my sister pulled from her car before it was impounded. All I have is the main control unit and I do not have the plug or wires that connect into the main unit. I was planning to solder each wire to each of the pins, but I don't know what all the letters mean on the...
  6. Plumbing
    I think I have a general Idea, but if someone could please draw me a basic diagram that would be great. Thanks!
  7. New Member Introductions
    I hope I have followed the instructions and examples correctly. I am hoping this ends up in the introduction section and not out of place. I did put a little blurb on my profile, and can get more detailed as we need to get. I have over thirty years experience of electrical motors and...
  8. Plumbing
    First, thanks in advance to all that read this post and provide any input. Well, renovation of plumbing is in progress and I wanted to ask for some advise from those that are much more experienced. I've attached a diagram for a new plumbing layout of the DWV system. Currently it is all Cast...
  9. Electrical
    As a VERY new member here, I am hoping someone will be able to tell me if these circuit loads look okay. I am trying to wire my unfinished basement and want to avoid adding a sub panel if possible. I want to make sure this looks feasible before I figure out the actual wiring routes and then...
Top