DIY Home Improvement Forum banner

condensor

  1. HVAC
    My fan on my A/C compressor unit seems to start and even spins up to a reasonable speed, although not quite the speed at which it ought to spin, but then 5 seconds later slows down to a very low speed where you can almost see the individual blades. The run capacitor was clearly blown (the top...
  2. HVAC
    Just bought a house with this current set up Goodman 4ton 2 stage 16 seer. I noticed the unit short cycles and seems is over sized for my house. The honeywell thermostat seems to kick in second stage far to quickly. I disabled the second stage via the programming and all seems well. It's running...
  3. HVAC
    The fan motor to our AC condenser has stopped working and we are looking for a new one. The existing one is as follows: MFG: GE MOTORS EQUIP MFRS #: HC39GE232A MODEL: 5KCP39FG V: 208 - 230 AMPS: 1.40 CAP: 5.00/370 HP: 1/4 RPM: 1100 We are trying to cross reference the above part, but...
  4. HVAC
    I have a duplex and had both of my tennants call me to say that the air conditioners are not blowing cold. They are completely separate. They are both split systems on seperate meters/panels. Both of the condensers? are on in the outside. The copper pipe that should be cold was not. I had a...
  5. HVAC
    I have wierd issue. I lost the run / start cap recently. I could bump start the fan and it ran what appeared a little slowly. This unit has run for 9 years with no issues - since new. I checked the input voltage - 230. So I replaced the fan and the 50/5 MDF 440 dual cap checked the voltages on...
  6. Electrical
    I have a question about what to do with Condensor unit wiring. The system I have specifies a minimum circuit ampacity of 30 amps. The unit also states that the minimum HACR circuit breaker should be 40 amps. I understand that this is permitted by article 440 in the NEC. The unit is wired...
  7. HVAC
    Hello all, I need to replace my amana heat pump condensor motor and I am having a hard time finding a replacement. The specs are as follows: General Electric Model: 5kcp39cf t483 s Hp 1/10 V 200-230 A .75 RPM 830 PH 1 5.6 Diameter If i get a motor from Grainger, do the specs including rpm and...
  8. HVAC
    OK. You guys helped me out a few weeks ago with an A/C suction line question and it really helped. I did have a tech come out and check my first unit and he said I did a good job insulating the suction line and the unit checked out OK. Tonight my second unit stopped working correctly. I...
Top