DIY Home Improvement Forum banner
centrifugal
1-2 of 2 Results
  1. Electrical
    Hi this is a century electric 2 hp , single phase, dual voltage, inductor motor with centrifugal switch, a starter cap and a run cap. Its wired at 110v but I want to change to 220V which the label diagram says it can be done. The problem is the label is marked coded by color wires but the wires...
  2. Electrical
    Hey all: I have a single-phase electric motor that powers my air compressor. The motor trips the breaker after a few seconds as it does not start. I have replaced the start capacitor to no avail. I can use a non-conductor and manually close the circuit on the centrifugal start switch and the...
1-2 of 2 Results
Top