DIY Home Improvement Forum banner

Search Results for ‘burner problem’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall walls water water heater window windows wire wiring wood
  1. Appliances
    I'm new here, so I'm not really sure what the correct terminology is, so I'll try to describe what happens... Our range has 5 burners. When you turn the knobs to "Lite" all 5 will "spark" (or at least they're supposed to) Recently, one of the knobs stopped telling the burners to spark. It's...
    burner problem frigidaire igniter range
  2. HVAC
    I have a regular hot water tank. I had the thermocouple and burner assembly cleaned. I notice that the pilot light stays lit as it should after the correct temp is achieved, but in the middle of the burner where the gas comes out there seems to be a little flame that stays lit as well. Is this...
    burner problem hot water problem thermocouple
1-2 of 2 Results
Top