DIY Home Improvement Forum banner
brass
1-5 of 5 Results
  1. Plumbing
    Seems like a silly question, but I bought all new 17 gauge brass P trap, but also need an extension piece that will go between the drain piece from sink and the P-trap cause new sink is taller. Yes I did Opt for the more expensive 17 gauge P trap in the thicker gauge, but for some reason when I...
  2. Plumbing
    Remodeling bathroom. Slab! Pulled toilet to remove old tile and install new toilet flange at proper height once new tile is installed. Discovered that original flange is brass, soldered to lead sleeve. Lead sleeve 4” tapering to 3” and glued into 3” PVC closet elbow about 3” below slab. Lead is...
  3. Project Showcase
    Hello again :smile:, This time I want to share with you my Necklace Project. It was the second time I worked with brass, but it turned out I love this material for homemade jewellery. Leave me some Feedback!
  4. Plumbing
    I've already read a few older threads here, but none seemed to address my issues exactly. I am gut-renovating my house, including the replacement/rerouting of every wire, pipe, tube, vent, and drain. I am trying to decide on the gas piping material I will use. My personal preference is to...
  5. Remodeling
    Hi Everyone: I have been working on installing some very old (approx 100 years) pocket doors which I have refinished. It has been a long an interesting project that has involved moving duct work, knocking out and reframing a wall, and refinishing the doors themselves. I am in the home...
1-5 of 5 Results
Top