DIY Home Improvement Forum banner
Cancel

Search Results for ‘branch circuit’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs stucco subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall walls water water heater window windows wire wiring wood
  1. Electrical
    While working on some stuff I noticed an 8-8-8 (w/ ground) service entrance cable being used in a regular branch circuit. Never seen this before, is there anything in the NEC that prohibits the use of SE cable in regular branch circuits? Should this be replaced with some 8/3 romex / nm-b cable...
    branch circuit circuit romex se cable service entrance
  2. Electrical
    I'm planning to trench about 350' to run a 120v branch circuit from my house to my property line at the county road. I want to add approximately 15 amps of lighting along my property edge. I was investigating the wire size needed so I could order my conduit. I read that NEC requires 3% voltage...
    branch circuit voltage drop
  3. Electrical
    Hi All, jerryh3 posted this link in another topic: http://www.monoprice.com/products/product.asp?c_id=105&cp_id=10425&cs_id=1042505&p_id=4652&seq=1&format=2 Which reminded me that I wanted to ask if something similar that I did is code compliant: What I have is a 15A circuit wired with...
    branch circuit code nec ups
1-3 of 3 Results
Top