DIY Home Improvement Forum banner
Cancel

Search Results for ‘bent’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting panel patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Windows and Doors
    I may have bent the metal forcefully with my door. It's 1.5" length. I tried pliers but made a small indentation and wasn't getting anywhere. Is there a tool or way to unbend it?
    bent door metal post steel
  2. Windows and Doors
    Hello all, today I was informed our garage door is busted. Upon inspection, it looks like someone tried to open it with the opener on the wall while the door itself was locked-- the top panel is bent inwards in the middle. I don't know much about garage doors, but it almost looks like if the...
    bent broken door garage opener
1-2 of 2 Results
Top