DIY Home Improvement Forum banner
Cancel

Search Results for ‘bar top’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall walls water water heater window windows wire wiring wood
  1. Painting
    I have a wood bar outside made of pressure-treated wood that has sat for a couple of months. We want the bar to have a slick surface like an indoor bar where you slide your beer across the top as we have a party in a couple of months where the bar will be used. My intent was to apply a Fix All...
    bar top polyurethane pressure-treated lumber
  2. Tiling, ceramics, marble
    I am re-finishing the surface of my gloss finished wood bartop with 12" by 12" glass mosaic sheets. I've done other tile jobs but nothing like this before. I plan on using a heavy Grit sand paper to scuff the surface then I'm unsure as to the 'BEST' adhesive to use. Thin set? Epoxy Adhesive...
    adhesive bar top glass mosaic tile
1-2 of 2 Results
Top