DIY Chatroom Home Improvement Forum - View Profile: Shadow99
Advertisement


Go Back   DIY Chatroom Home Improvement Forum > Members List

CLICK HERE AND JOIN OUR COMMUNITY TODAY...IT'S FREE!

Shadow99 Shadow99 is offline

Deleted Member

About Me

  • About Shadow99
    Biography
    No one has written a biography on me yet. Open to offers though
    How did you find DIYChatroom.com?
    I find it Ok, so far
    Location
    Canada
    Interests
    Interests ? I'm a guy, whadda think ;)
    Occupation
    Washroom Attendant

Statistics

Total Posts
Blog
Total Thanks
General Information
  • Last Activity: Yesterday 09:25 AM
  • Join Date: 11-03-2017
  • Referrals: 0

Friends

Showing Friends 1 to 2 of 2

Mentions

07-18-2019
11:37 AM - CodeMatters mentioned Shadow99 in post Re: Old work: Adding new circuit through stud at electrical panel.
...box/panel. jbfan or Shadow99 may have specific in...
06-25-2019
09:16 AM - Shadow99 mentioned SPS-1 in post Re: plug assist for elderly
...ling plug puller as SPS-1 suggested. https://w...
04-25-2019
07:25 AM - Shadow99 mentioned CodeMatters in post Re: If it's 80 ft long wire (20amps) a considerable problem for voltage drop?
...eptacles, then what CodeMatters said will be fine.
04-01-2019
04:01 PM - CodeMatters mentioned Shadow99 in post Re: Taking chances with unlicensed persons doing electrical work
....... You, me, and Shadow99 should meet up for a...
01-02-2019
02:10 PM - amadago mentioned Shadow99 in post Re: Outlet Failure
Thanks Shadow99 and Oso954 - clearly...
10-07-2018
01:31 PM - Shadow99 mentioned joed in post Re: generator panel, switch neutral?
...and 60A Link for @joed https://www.schnei...
08-31-2018
09:28 AM - Shadow99 mentioned carmusic in post Re: 2220W or 1500W electric demo hammer? outlet capacity
...others got less. As carmusic mentioned, it's mfr ...
08-24-2018
06:46 PM - CodeMatters mentioned Shadow99 in post Re: Checking power?
... who do are jbfan , Shadow99 , and electraglide ....
01:46 PM - CodeMatters mentioned Shadow99 in post Re: Exterior transformer and multiple circuits
...onally I'd consider Shadow99 's advice above and ...
08-10-2018
11:13 AM - Shadow99 mentioned fishbulb in post Re: Garage Heaters
...u may want to check fishbulb 's album https://www...
06-12-2018
08:43 PM - Shadow99 mentioned CodeMatters in post Re: I cant figure out my baseboard heater thermostat wiring.
...e same space. As @CodeMatters said, the device ne...
06-09-2018
11:14 AM - CodeMatters mentioned Shadow99 in post Re: Discovered Existing wiring is 10 gauge on 40 amp circuit
...) & (7) Thanks to Shadow99 for politely pointin...
06-03-2018
09:01 AM - CodeMatters mentioned Shadow99 in post Re: Where is the GFCI?
...the gnd path. Like Shadow99 said, a qualified el...
04-29-2018
07:10 AM - CodeMatters mentioned Shadow99 in post Re: Failed Inspection for AC
...oo. Same reasons as Shadow99 and also BX. If Can...
04-08-2018
03:19 PM - CodeMatters mentioned Shadow99 in post Re: Adding a 220v to almost full existing box
... pole breaker. As Shadow99 pointed out, the bre...
03-23-2018
01:24 PM - Shadow99 mentioned Oso954 in post Re: Deciphering Chinese gear motor plate
... It's a 0.41 FLA as Oso954 said. The 1.0 is th...
02-27-2018
01:14 PM - Shadow99 mentioned Gregsoldtruck79 in post Re: Couple questions about aluminum wiring
...read The document Gregsoldtruck79 posted is a must rea...
02-24-2018
06:23 PM - Shadow99 mentioned lenaitch in post Re: Dropping flex cable to a water heater
...perforated strap as lenaitch suggested .
01-28-2018
08:49 PM - CodeMatters mentioned Shadow99 in post Re: any musicians here?
There's guy named Shadow99 around here somewher...
01-18-2018
12:47 PM - Shadow99 mentioned Oso954 in post Re: Generator won't run gas furnace
...to ground, but as @Oso954 said in post #12 , ...

Quotes

07-14-2019
11:13 AM - form8829 quoted Shadow99 in post Re: Not getting 240v on a Siemens Q1520 breaker
At HWT? you mean at the water...
07-11-2019
02:29 PM - Fishbulb28 quoted Shadow99 in post Re: Can a light be directly wired to breaker box bypassing a switch
Why a SWD breaker ?? My under...
06-20-2019
01:42 PM - 2Quiker quoted Shadow99 in post Re: Outlet voltage drop
18% :surprise: Is your house...
06-01-2019
11:33 AM - SteveR73 quoted Shadow99 in post Re: 208V 3ph motor high amper question
The main problem I see (but I...
10:42 AM - SteveR73 quoted Shadow99 in post Re: 208V 3ph motor high amper question
Not sure what specs you're re...
05-14-2019
12:32 PM - lmcancu quoted Shadow99 in post Re: uses for 12/2 "red" wire Canada/Quebec code
It wouldn't be any 'better' ....
01:07 AM - FrodoOne quoted Shadow99 in post Re: Electrical Engineer GPM-Volt drop?
I The reduction in voltage (1...
05-13-2019
07:59 AM - MiataBoy quoted Shadow99 in post Re: # of outlets on 20 amp breaker 12/2 wire
"accepted" ?? Required is in...
05-03-2019
06:41 PM - ElectricIQ quoted Shadow99 in post Re: Plumbing current and grounding question
When/if you isolate the water...
03:51 PM - ElectricIQ quoted Shadow99 in post Re: Plumbing current and grounding question
Either get an electrician out...
04-13-2019
03:58 PM - rjniles quoted Shadow99 in post Re: 12 AWG circuit, 14 AWG cable for the last load -- a switched light
There are tap rules for light...
04-07-2019
06:52 PM - Drachenfire quoted Shadow99 in post Re: What is this thing?
Back in the day, they had a b...
04-06-2019
09:42 PM - supers05 quoted Shadow99 in post Re: What is this thing?
Yeah, I'm surprised it hasn't...
03-31-2019
06:41 AM - John Snow quoted Shadow99 in post Re: Taking chances with unlicensed persons doing electrical work
What are YOU doing here ?? Yo...
03-30-2019
07:30 PM - jbfan quoted Shadow99 in post Re: Taking chances with unlicensed persons doing electrical work
What are YOU doing here ?? Yo...
02-04-2019
10:32 AM - Andy370 quoted Shadow99 in post Re: residential service Ontario
Ampacities for conductors/cab...
01-10-2019
07:16 AM - responsibleJ quoted Shadow99 in post Re: What Gloves Would You Advise
Sorry, not wanting to derail ...
01-07-2019
08:18 PM - spacefrog quoted Shadow99 in post Re: Which Circuit for Garage Door Opener and Appropriate Subpanel Amp Size
I personally wouldn't put in ...
10:38 AM - MTN REMODEL LLC quoted Shadow99 in post Re: 14.0 KW Oven, 40 Amp breaker??
Ranges are covered under NEC ...
09:18 AM - timkoupe quoted Shadow99 in post Re: 14.0 KW Oven, 40 Amp breaker??
Ranges are covered under NEC ...



Top of Page | View New Posts