DIY Chatroom Home Improvement Forum - Mystriss's Album: Computer Case Modding
Advertisement


Go Back   DIY Chatroom Home Improvement Forum > Photos > Mystriss's Profile > Albums

CLICK HERE AND JOIN OUR COMMUNITY TODAY...IT'S FREE!

 
Computer Case Modding
Custom computer case modding and related computer stuff.
In one of my mods I made all my "cables" out of rigid  "wire."  I bent them all like a circuit board.  It looked so EPIC.  (I did multi-colored...
Oh no, my GPU was too long for my HTPC case!  What ever will I do?!?
No worries!  External PSU mod to the rescue.  (It had a programmable LED panel that showed chat notifications, temps, and custom messages - basically...
A custom braided 24 pin MB cable I'd made for the external PSU mod.
A custom braided 24 pin MB cable I'd made for the external PSU mod.
Custom braided PCIE cable with el wire lighting for the external PSU mod.
Custom braided PCIE cable with el wire lighting for the external PSU mod.
Another crazy custom cable mods.
Another crazy custom cable mods.
The rest of these are from my last mod project. 
 
One of my two GPU waterblocks
My CPU waterblock
Test fitting the Monsoon dual horizontal reservoir with aquaero d5 pumps on either end for my separate GPU and CPU loops.  (The GPU air shield was a...
I put supports in my computer hutch to mount my monitors
Bent a sheet of black acrylic to cover the ugly supports.
Ta da!
Triple monitor achievement reached!
Drilling 120mm holes in the side of the desk hutch for my GPU rad
Smexy stainless rad cover on the exterior of the desk hutch.
GPU radiator, backup pump, & aquaero flow meter on the inside of the hutch
I built a "stereo rack" style stand to hold my A/V receiver and the two HTPC cases.
One of the first things I had to do with the chassis is center the motherboard in the top case since the PSU would be in the second bottom case.  I...
Cut out a new back out of brushed aluminum.
Centered the I/O and PCIE slots.
With the motherboard centered I cut out the big window in the top.
Quick picture of the bottom case that held my PSU and hard drives plus the CPU rad - I had also later put in an ITX system for occasional dual boxing.
 



Top of Page | View New Posts