DIY Home Improvement Forum banner

stopping/starting VCT installation

1K views 4 replies 3 participants last post by  Bud Cline 
#1 ·
I have more square footage to do than I can install in 1 day. Is there anything I need to know to stop and start back up, without it being obvious where I stopped? Does the glue stick up enough that I need to scrape it off, or do I even need to worry about it?
 
#4 ·
that wasn't really what i meant. I snapped a chalk line where i was stopping. Its hard to stop the glue EXACTLY on the line. I glued probably an 1/8" past the line in most spots, i wasn't sure if i needed to scrape the extra glue off the next day because that will make a highspot or does it matter. The next day do i just start glueing where i left off?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top