For the programming of the remote:
(1) The brand switches were set to 4 dip switches off for Stanley.
(2) For the 1-10 dip switches I matched the settings with the garage door opener - off is marked as open on this model. This model only has 10 dip switches (I tried the opposite setting too for 1-10).
(3) The switches 11 and 12 are set to off.
See photos for details of the actual programming.
I put a new battery in and the LED on the remote is clear yellow, when I program it or try to open the garage door.
Is there a way to check if the Stanley receiver works? I do not see any LEDs on it. Any suggestions?