DIY Home Improvement Forum banner

Base board over tile

1K views 12 replies 5 participants last post by  Mike Milam 
#1 ·
I have a hill to climb here. Attached is a photo of an alcove where I will be putting in a 60 X 36 whirlpool tub. The pony wall on the left is the wet wall. After the tub is in I will drywall the surrounding area with green board and tile up about 12 inches. I plan to take the tile all the way to the door facing and down to the floor. I plan to put baseboard at the floor from the tub to the door facing. My concern is the thickness of the tile will make the baseboard stand proud of the door facing at least 1/4 inch. How would you guys address that? Bevel the end of the baseboard at the door facing? Other ideas? Thanks
 

Attachments

See less See more
1
#3 ·
Thank you! I hadn't considered not using baseboard. I could just put 1/4 round from the door to the tub. I was stuck on finishing the seam where the tile met the floor.
 
#4 ·
To address the original question, yes, bevel the molding, then flat cut the end to where it reveals the 1/4" you need to sit back in the door molding indentation.

But I like Mark's answer and go without the base altogether.
 
  • Like
Reactions: Mike Milam
#5 ·
You can tile the wall first, below the floor tile level but with expansion/shrink space, then finish with floor tiles. Wet saw with sharp blade gives you a good edge and maintain even grout joint. File the cut edge smooth. You should use cement board against the tub. Greenboards will soak up water. Cement board with redguard coats is about the best.
 
#6 ·
Slight change in plans. How would it look to set the baseboards at both ends all the way to the tub and end the tile at the baseboard when it comes down? I have now decided not to tile the wall all the way to the door. I plan to bring the tile out to the edge of the pony wall and do the other end out the same distance from the tub. I feel the two ends would look better symmetrical.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top