DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Electrical
    I had a contractor kill my all of my new exterior security lights while pressure cleaning, so I called an electrician to make sure the wiring hadn't been shorted or damaged. I had installed before in two hours swapping out old with new, easy enough. job is done, all works fine but the bill is...
  2. HVAC
    The manual discusses distances for the line set based on the condenser being above or below the evaporator coils. My house is a single story house with the FAU located in the middle. The line set will be running from the condenser up to the attic over to the center of the house and down again, a...
  3. HVAC
    Hello, I have read that R410a should be added to a system as a liquid. But I have not read where there is really any issue with adding R410a as a gas to the low side service port? As long as it is added slowly, does anyone see a real problem with adding R410a to the suction service port at the...
  4. HVAC
    Hi guys, Got a goodman 2.5 ton gsz130301 heatpump.. with matching aruf303016 air handler Comes pre-charged for 15ft. Im running 30ft and the 410 was evacuated-- long story. Now would like to know beforehand the ballpark amount of r-410 needed for a full charge. There is no info seen so far. Is...
  5. Electrical
    My wife and I just bought a house with a 100 amp panel and we are going to upgrade to 200 amps as we want to have a hot tub put in. Our first estimate for this project came in at 3000 dollars. We asked the electrician to break down the costs and submitted as follows: 1) Install new 200 amp...
1-5 of 5 Results
Top