- About kwikfishron
- Framing/Siding/Finish...Oregon for most of my life, KCMO these days.
- How did you find DIYChatroom.com?
- I Googled something that brought me here.
- Kansas City
- Fishing, NASCAR
- A Picture Is Worth A Thousand WordsEspecially In The DIY Chatroom
|05:19 PM - MAW74656 mentioned kwikfishron in post Re: Where to find this simple bracket
kwikfishron - Interesting to kno...
|09:38 PM - kwikfishron mentioned ErnieMccracken in post Re: How can I reach this spot on my roof?
...and Western US. ErnieMccracken...get more quotes. I...
|09:29 PM - Cricket mentioned kwikfishron in post
|12:16 PM - Cricket mentioned kwikfishron in post
|04:49 PM - Cricket mentioned kwikfishron in post
|08:46 PM - miamicuse quoted kwikfishron in post Re: Cutting down a tall stem of bamboo
Screw a couple of 2x's or 4x acr...
|07:16 AM - kwikfishron quoted miamicuse in post Re: Cutting down a tall stem of bamboo
I am thinking about cutting th...
|04:59 PM - beenthere quoted kwikfishron in post
|03:54 PM - kwikfishron quoted joetab24 in post Re: 2 Questions: Wire and Caulk
would it be recommended to pu...
|03:25 PM - kwikfishron quoted Elkie in post Re: Replacing Deck Support Posts
I had a deck contractor lo...
|08:34 PM - kwikfishron quoted Stephen S. in post Re: Building "stop" before raising wall on concrete pad
I am going to raise a frame wal...
|05:33 PM - kwikfishron quoted 99ls1tj in post Re: Deck ledger flashing around corners?
Hi, I'm looking for some tip...
|06:13 AM - kwikfishron quoted cloves in post Re: Starter Strip, Flashing, & Watertable Starting Point
So when all is said and don...
|03:23 PM - kwikfishron quoted Kory Beam in post Re: Proper nails for siding/exterior trim
$4.68 LF for 1x12. . I wo...
|03:09 PM - kwikfishron quoted Kory Beam in post Re: Proper nails for siding/exterior trim
I did like the look of the res...
|10:38 AM - kwikfishron quoted HDS in post Re: Cutting concrete slab to make it square
I'm not as worried about...
|10:27 AM - HDS quoted kwikfishron in post Re: Cutting concrete slab to make it square
Well that sucks. It sounds like ...
|10:12 AM - kwikfishron quoted HDS in post Re: Cutting concrete slab to make it square
I set up some stakes as ...
|09:45 AM - HDS quoted kwikfishron in post Re: Cutting concrete slab to make it square
14" out of square??? I'd make th...
|04:29 PM - kwikfishron quoted joecaption in post Re: Two questions about OSB sheathing
Smooth side out. Structur...
|09:45 AM - Fix'n it quoted kwikfishron in post
|09:07 AM - Fix'n it quoted kwikfishron in post Re: very inexpensive post caps
Make something out of wood. Have...
|09:04 AM - kwikfishron quoted Fix'n it in post Re: very inexpensive post caps
i am looking for something re...
|05:14 PM - kwikfishron quoted mako1 in post
|12:54 PM - Canarywood1 quoted kwikfishron in post Re: dual (recip) saw
Hmm......Well then you don't hav...