DIY Home Improvement Forum banner

Wood stove and metal roof problem

4K views 6 replies 4 participants last post by  mesquitemagnoli 
#1 ·
We installed a wood burning stove with proper installation kit through out and we have a metal roof. It required a rubber boot kit. On the side where the boot and the stove pipe come through the roof, there is a gap 1 1/2 inches long and about 1/2 inch wide. What can we use to fill the crack?
 
#2 ·
Get the right size boot, it's obviously too big. It should be clamped anyways so you could try seeing if the clamp will close the whole thing but I doubt it.
BTW, I sure hope that's triple-wall pipe you used a boot on otherwise it's going to be a much bigger gap once it heats up.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top