||01-05-2011 12:44 PM
Rheem On Demand Water Heater
I installed an on demand hot water heater 9 months ago Rheem brand. Over the past 2 weeks when I have tried to run bath water I could only get a few seconds of hot water. I unplugged it the first time and it seemed to heat the water again but last night it did the same thing. I wasn't able to get anymore than a few seconds of hot water. I have only had this issue with running a bath, not a shower. Does anyone have any ideas?
||01-05-2011 03:30 PM
Somewhere inside there is a water pressure or flow sensor that turns the heater on. Check that to see how well it is working. Clogging with sediment is not unusual.
|All times are GMT -5. The time now is 04:57 AM.
Copyright © 2003-2014 Escalate Media LP. All Rights Reserved