DIY Home Improvement Forum banner

Price pfister tub stopper problem

3K views 2 replies 2 participants last post by  rocboz 
#1 ·
I have a Price Pfister lever type tub stopper/overflow assembly in my bathtub. The lever was not operating the stopper. I took apart the chrome lever assembly. The threaded rod inside had come loose and was no longer attached to lever assembly. When I look down the overflow line the rod is no where to be seen. Is there a way to reteive the rod/nut to reattach it to the lever assembly?

Any help would be greatly appreciated.


Unplugged
 
#3 ·
Got the stopper out and replaced the entire assembly including waste shoe, overflow, etc.

Replaced the hot, cold and diverter vavle stems & seats. After I tightened the new diverter valve down, the handle does not turn enough to allow shower to operate. When I loosened the stem assembly a little, handle turns & shower operates, but leaks slowly at handle/stem assembly. Anyone know the reason this is happening?

The Dribbler
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top