new sewer line
i am seeking validation.
i have built a new addition with a small bathroom.
there is a toilet, shower, and sink.
the toilet goes into a 3" PVC and out to a 3" clean-out. the breather is 2" PVC through the roof and the shower is 2" PVC with a 'P' trap connecting to the 3" PVC right before the clean-out. the sink is a 1 1/2" PVC connecting into the 2" PVC breather 16" up from the floor.
the length of the 3" PVC to the house main 4" 'pipe' is 74 feet.
the 3" PVC goes into a 3" / 4" adapter connected on both sides via rubber boots with SS clamps to the existing 4" prehistoric( black stuff but not metal ) house sewer pipe.
the difference in height from the clean-out to this connection is 2 feet.
have i 'hosed' this as an amateur :( or did i luck out :) and understand all the bajillion of "do this's" and "don't" do that's in the code books?
Sounds right to me. :):):)
What fitttings used and where and how is the questions I would have.
45 degree fittings on the following:
breather into main
shower into maiin
sink into breather
cleanout into main
BR main after the clean-out into the run down to the house line
BR main into the existing house line
straight fittings used for the main PVC going 74 feet ( 10 foot sections )
is used that special purple stuff before i used the special PVC glue
the only connection not glued:
rubber boots and SS clamps where the new BR main connects to the existing house pipe.
Sounds right to me.
|All times are GMT -5. The time now is 08:47 PM.|
Copyright © 2003-2014 Escalate Media LP. All Rights Reserved