DIY Chatroom Home Improvement Forum

DIY Chatroom Home Improvement Forum (http://www.diychatroom.com/)
-   Plumbing (http://www.diychatroom.com/f7/)
-   -   Mixer valve to transfer valve installation (http://www.diychatroom.com/f7/mixer-valve-transfer-valve-installation-117110/)

CarlV 09-13-2011 11:28 AM

Mixer valve to transfer valve installation
 
I set my tub and I'm ready to rough in my plumbing. I have a mixer valve (Kohler K-304) and a transfer valve (Kohler K-728) that will go to tub faucet, shower head and hand-held shower. My mixer valve has 1/2" supply for hot and cold and 1/2" out for shower and faucet. So I'm assuming I plug one of the outs and run the other out to the transfer valve. The transfer valve has 3/4" "mixed" supply in and 3 X 1/2" outs. Can someone please explain the point of 3/4" mixed supply on a transfer valve if the mixer valve only has 1/2" out? Do I just size up from 1/2 to 3/4? Will there be any water pressure issues?

Also, does the transfer valve normally get installed above the mixer valve?

Thanks in advance for any answers you can give.


All times are GMT -5. The time now is 07:14 AM.


Copyright 2003-2014 Escalate Media LP. All Rights Reserved