Go Back   DIY Chatroom Home Improvement Forum > Home Improvement > Flooring


Thread Tools Search this Thread Display Modes
Old 03-10-2010, 11:10 AM   #1
Join Date: Jan 2010
Location: NC
Posts: 163
Rewards Points: 150

Uneven hw floor to vinyl transition

My kitchen vinyl floor is 1/2" above my subfloor in my living room (where we just layed prefinished 3/4" oak). I was going to use the prefinished reducer strip with groove, but it is uneven. Is there an easy way to carve the 1/2" off of the bottom of the reducer strip. I don't have a table saw. Other ideas? I guess I could cut the vinyl back, but would prefer to go over tiop instaed of meeting the two.

*This is a flush reducer...would like to avoid an overlap reducer...we're a clumsy family.

Last edited by joemontana16; 03-10-2010 at 11:16 AM.
joemontana16 is offline   Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
Installing vinyl plank over existing, uneven floor? AKCDIY Flooring 5 11-01-2014 05:48 PM
Transition from grouted vinyl tile to carpet MI-Roger Flooring 2 11-29-2009 01:55 PM
Siding: Aluminum vs. Vinyl Grumpy Remodeling 1 03-19-2005 01:55 PM
Siding: Aluminum vs. Vinyl Grumpy Remodeling 0 04-18-2004 04:35 PM

Top of Page | View New Posts

Copyright © 2003-2014 Escalate Media. All Rights Reserved.