DIY Home Improvement Forum banner

screw heads and red oak flooring

905 views 2 replies 3 participants last post by  AGWhitehouse 
#1 ·
Some of the screws are not completely flush with my plywood sub floor I installed in preparation for my hardwood floor. They don't stick up much, probably 1/32" or less. Is this going to be a problem?

The bit from my drill stripped out the head of the screw before the screw drove in deep enough.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top