DIY Home Improvement Forum banner

Husky Compressor

2K views 1 reply 2 participants last post by  joecaption 
#1 ·
I have a 26 gl. Husky compressor Model# 585-819 built in 2009. When I turn it on,it will run for just a few minutes and then the Red overload button pops out. It only get up to maybe 15 to 20 psi and pops out. I normally can just walk over to it push the button back in and it fires right up, but then it just pops again in several seconds. I removed it from a extension cord and tried running it right into a 20a 100v outlet, but it stills pops the button. Really doesn't have that many hours on it, it was used maybe 2 hours a day, five days a week and that's pushing it some.
 
#2 ·
I think I would remove the check valve and make sure it's not stuck. If it's stuck hardly an air can get to the tank and it over loads the compressor.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top