Still Looking For That Table Saw - General DIY Discussions - DIY Chatroom Home Improvement Forum

Go Back   DIY Chatroom Home Improvement Forum > DIY Forum > General DIY Discussions


Thread Tools Display Modes
Old 07-12-2011, 02:28 PM   #1
Join Date: Nov 2009
Location: ohio
Posts: 34
Rewards Points: 33

still looking for that table saw

I came across a Delta Contractor saw Model#34-444 listed as excelent condition, this was on Craigslist @ $250.00 not sure how old this saw is, but looking for input on the price ,any info would help


jjchips is offline   Reply With Quote
Old 07-12-2011, 04:20 PM   #2
DIY Hack
Mr Chips's Avatar
Join Date: Mar 2008
Location: Location, Location
Posts: 1,306
Rewards Points: 506

That saw was a top of the line about 20- 30 years ago, and still considered a good saw today. $250 isn't a bad price, especially if its the cast iron version. I have seen them go for about half that price though....


Those who can, do...
Those who can't criticize on the internet
Mr Chips is offline   Reply With Quote
Old 07-13-2011, 06:22 AM   #3
Join Date: Dec 2008
Location: Wilmington, DE
Posts: 3,118
Rewards Points: 2,000

How old is it?? The older ones are better, new stuff is just not the same. That one is a belt drive. There was a model just under that which was direct drive amd very underpowered. Bought mine in '91, has had few problems. I wanted a cabinet saw, but could not justify the money. Contractors saw has done well for me.
Just Bill is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
Super glaze bar table finish jlwiu1 General DIY Discussions 18 02-05-2016 03:52 PM
Powered outlet on table saw outfeed table? b_corwin Electrical 11 04-12-2010 06:23 PM
Tressle table - how to build? Knucklez Carpentry 1 10-24-2009 03:18 PM
Need Advice for Adding Wheels to Table HandyDottie Carpentry 7 01-27-2008 07:44 PM
Question about table saws,... tribaloverkill Tools 28 04-13-2007 08:47 AM

Top of Page | View New Posts


Search Engine Friendly URLs by vBSEO 3.6.1