DIY Chatroom Home Improvement Forum

DIY Chatroom Home Improvement Forum (http://www.diychatroom.com/)
-   General DIY Discussions (http://www.diychatroom.com/f2/)
-   -   still looking for that table saw (http://www.diychatroom.com/f2/still-looking-table-saw-110527/)

jjchips 07-12-2011 03:28 PM

still looking for that table saw
 
I came across a Delta Contractor saw Model#34-444 listed as excelent condition, this was on Craigslist @ $250.00 not sure how old this saw is, but looking for input on the price ,any info would help

Mr Chips 07-12-2011 05:20 PM

That saw was a top of the line about 20- 30 years ago, and still considered a good saw today. $250 isn't a bad price, especially if its the cast iron version. I have seen them go for about half that price though....

Just Bill 07-13-2011 07:22 AM

How old is it?? The older ones are better, new stuff is just not the same. That one is a belt drive. There was a model just under that which was direct drive amd very underpowered. Bought mine in '91, has had few problems. I wanted a cabinet saw, but could not justify the money. Contractors saw has done well for me.


All times are GMT -5. The time now is 06:17 PM.


Copyright 2003-2014 Escalate Media LP. All Rights Reserved