I Have A AOSmith Motor # F48AB79E10 Need Help With Wiring To Pool Cover Controls - Electrical - DIY Chatroom Home Improvement Forum

Go Back   DIY Chatroom Home Improvement Forum > Home Improvement > Electrical


Thread Tools Display Modes
Old 11-13-2012, 11:55 AM   #1
Join Date: Nov 2012
Location: Arizona
Posts: 1
Rewards Points: 10

I have a AOSmith motor # F48AB79E10 need help with wiring to pool cover controls

The motor has 4 wires, black,red, white, and green. The junction box has 5 wires, black, red, yellow, blue green. there is a switch that opens and closes the cover that runs into the jbox. there are also sensors to make sure the cover stops at the correct place. Can you help me figure out how to make this work.


Last edited by Terry Maze; 11-13-2012 at 12:00 PM.
Terry Maze is offline   Reply With Quote
Old 11-13-2012, 01:30 PM   #2
joed's Avatar
Join Date: Mar 2005
Location: Welland, Ontario
Posts: 13,448
Rewards Points: 13,696
Blog Entries: 11

Not without a lot more info about the controller and the sensors. The only thing I can say for sure is the green is the ground wire.


joed is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
wiring gas pool heater - Ontario ESA 2buddy Electrical 0 06-12-2012 12:13 PM
DIY Pool cover reel system tips timp General DIY Discussions 15 06-15-2011 08:32 PM
Pool cover repair tanyashka Landscaping & Lawn Care 0 09-28-2009 07:20 AM
Sunset Basic Home Wiring cover is wrong? CareBear Electrical 3 09-03-2009 10:31 AM
Washer agitator/spinner turns one way, but not the other IckesTheSane Appliances 5 01-10-2009 02:53 AM

Top of Page | View New Posts


Search Engine Friendly URLs by vBSEO 3.6.1