I saw some of your posting's and advice given and wondered if you could lend some advice my way? i am replacing a furnace control module on our american standard freedom 90 the old board had water splashed on it, I know the board is the only problem since we have two of these unit's and i switched boards and igniter's. The supply store sold me a honeywell S9200U1000 universal board which i don't have a problem with since the box reflects that it will replace the white rogers number i previously had. There were no questions with the wiring changeover on the the respective terminals but i am curious about dip switch settings. this is where i think my problem rests (maybe im right maybe im wrong). Any help would be greatly appreciated.
Any ideas before i get fleeced??
Linear Mode
