Miller Oil furnace in a mobile home
I have a Miller Furnce which we burn kerosene because our tank is outside. We just had a repairman work on the furnace and it now runs fine except it just finishes a cycle and less than a minute later it starts again but shuts off after running just a minute or so. It did not do this prior to the repair work that was done. does anyone have any ideas why it is doing this?
Is it the burner that is restarting, or just the blower. blower is getting rid of residual heat. Burner may have been under fired before, or over fired now. Could be the old nozzle was restricted and not burning as much oil as it should have been.
What did the service guy write down that he did.
|All times are GMT -5. The time now is 02:14 AM.|
Copyright © 2003-2014 Escalate Media LP. All Rights Reserved