DIY Home Improvement Forum banner

Clayton woodburner wiring

7K views 12 replies 3 participants last post by  DavePts 
#1 ·
I recently purchase a used Clayton woodburning furnace. I need a wiring schematic but so far everyone I received from US Stove is for wiring a Honeywell. Ths furnace is a model 7.1 and doesnt have honeywell equipment. It has a printed circuit board with 3 connectors The top connector has two wires which go to the draft blower; the middle connectoris for power to the circuit board. the third connector has 4 wires, black blue red and white. I need to know how to connect these to run a 3 speed blower. If someone has a Clayton woodburner with a circuit board your help would be greatly appreciated.
 
#13 ·
Wiring is correct

I bought the Clayton Stove (used) a few years ago and have the same board that you do. mine was working up until one of the connectors shorted out.


I'm not an electrician, but when the stove is running, there is power from the black (hot wire) going to the board. Once the box gets up to temp, one of the colored wires on the four prong connector goes hot, and the rear blower motor kicks on.

Please let me know if you need any more specific info....

Dave
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top