I have recently replaced the Draft inducer motor / fan kit on my furnace. Now when I go to turn it on I notice it does not ignite all 4 burner tubes. It will ignite the first three (looking in and going from right to left).
I powered off the furnace using the switch on the side and it did the same thing when I powered it back on. So I power cycled it again and then it lit all 4 burners.
Does anyone have any suggestions?
I powered off the furnace using the switch on the side and it did the same thing when I powered it back on. So I power cycled it again and then it lit all 4 burners.
Does anyone have any suggestions?