DIY Chatroom Home Improvement Forum

DIY Chatroom Home Improvement Forum (http://www.diychatroom.com/)
-   Carpentry (http://www.diychatroom.com/f14/)
-   -   siding repair (http://www.diychatroom.com/f14/siding-repair-20445/)

chilangopolaco 04-29-2008 09:09 AM

siding repair
 
I have replaced 7 sheets of rotten siding. I have used hardi pannels and hardi trims. I have a dillemma whether I should go up and cover the sticking out flashing with 1X6 and ugly seams with 1X4 following the pattern at the bottom ? Is there some air circulation issue (can flashing in the siding be covered ?).

before
http://i282.photobucket.com/albums/k...o/000_0009.jpg

After

http://i282.photobucket.com/albums/k...o/IMG_1621.jpg
http://i282.photobucket.com/albums/k...o/IMG_1622.jpg
http://i282.photobucket.com/albums/k...o/IMG_1623.jpg
http://i282.photobucket.com/albums/k...o/IMG_1624.jpg


Also I was planning to cover those ugly seam with 1X4 on the rest of the siding. The siding is not rotten at the bottom so I can leave it as is, just add 1X4 along the flashing and seams .. Is it a good idea ?

http://i282.photobucket.com/albums/k...o/IMG_1619.jpg
http://i282.photobucket.com/albums/k...o/IMG_1620.jpg
http://i282.photobucket.com/albums/k...o/IMG_1618.jpg

Termite 04-30-2008 11:58 AM

You're asking for trouble by not flashing the 1x4's and horizontal seams as one unit. I don't see any z-bar flashing at the top of the sheet of hardie board.

Never cover flashing with 1x4's or anything else. Incorporate them into the flashed system if you want them.


All times are GMT -5. The time now is 02:33 PM.


Copyright 2003-2014 Escalate Media LP. All Rights Reserved