Clamping Board w/ sawhorse
I am using powertool version of shears to cut 1/2 hardi-backerboard. I need to clamp the backerboard to sawhorses or similar to get a good cut. Any tips? or any special clamps?
My sawhorses are those plastic ones that fold; like these. The sawhorses bend when I clamp to them.
Thanks in advance!
Screw a sheet of plywood to the sawhorses, then clamp the Hardi to the plywood.
|All times are GMT -5. The time now is 07:39 PM.|
Copyright © 2003-2014 Escalate Media LP. All Rights Reserved