How to Install a Dishwasher: Part 1 by Expert Village

I’m Lee. I have a degree in architecture and about ten years construction experience, and we’re installing a new dishwasher. The water inlet, which is, everything’s located on the bottom. You just want to take some Teflon tape and... Read More »

How to Hook Up Sink Angle Stops by Expert Village

We're hooking up the angle stops for the water supply to the sink right now. I've got the cold water side done and now I'm going to do the hot water side. I've got to cut this cap off the copper pipe and then fit the valve onto the pipe, so, let's go... Read More »

Ball Valve Installation Essentials by Expert Village

Hi! This is John on behalf of Expert Village. In this video clip, I will be showing you step 3 in installing a ball valve. For this step, I will be marking and cutting my ball valve. On our ball valve, our pipe will stick inside of the valve on each end... Read More »

Drilling the C Pipe for a Xylophone by Expert Village

Now it's time to drill. So that we can thread our pipe and tune it and attach it to our xylophone bar, so what we're going to do is we're going to use a vice grip. We're going to put it in the pipe holder section of that vice grip. Then we're going to... Read More »

Cutting the D Pipe for a Xylophone by Expert Village

Now the next step is going to be to cut the D. Now, the last note, the F, no the E, worked out pretty well at it was 10.5 inches, ten and a half inches. So this next one we're going to go for just about eleven inches, play it safe. Use or pipe cutter... Read More »