DIY Chatroom Home Improvement Forum - lbeers
Advertisement


Go Back   DIY Chatroom Home Improvement Forum > DIY Blogs


CLICK HERE AND JOIN OUR COMMUNITY TODAY...IT'S FREE!

Old

furnace will not stay lit

Posted 01-08-2017 at 06:43 PM by lbeers

Update to previous blog.

The only tube to ignite during the initial start up is the far left one where the igniter is. None of the others ignite.
So how does the flame sensor get enough heat to ignite the other tubes? Or is the flame sensor not allowing the other tubes to light?
Newbie
Posted in Uncategorized
Views 443 Comments 0 lbeers is offline
Old

furnace will not stay lit

Posted 01-06-2017 at 05:46 PM by lbeers

I have a Luxaire 95% Furnace/Heat Pump which was installed in 2011.

The furnace tries to light 3 times but won't stay lit.
When it cycles these 3 times it then gives me 7 red flashes. Which is lock out do to retries.

I cleaned the flame sensor but that did not help.

Any suggestions will be much appreciated.

Model # TG9S100C16MP11A
Serial # W1D0748003
Input 100000
Output 95000
Newbie
Posted in Uncategorized
Views 281 Comments 0 lbeers is offline



Top of Page | View New Posts

 

Search Engine Friendly URLs by vBSEO 3.6.1