👋🏻 Welcome To DIY Chatroom
DIY Forum
Home Improvement
Do It Yourself
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Forum Support
Latest Posts
-
I installed an interlock switch to run a 30 amp inlet for my generator on my last house pretty easily. It was straight forward as it was just a typical box with a main 200 amp breaker and I just put in a 30 amp to switch to when I was on generator power. I have ran into a problem with my new...1 reply 24 views
-
I am sure this has been covered 1000 times. But I was at a friend who is running two circuits in one raceway from his sub-panel (Sub-Panel is a workshop not connected to the house. Sub-Panel does have a ground going to a ground rod outside shop). Long story short- I disagree with the electrical...26 replies 266 views
-
This is a follow-up to a previous post about a clothes washer that wouldn't go into diagnostic mode. Well after replacing the control board and shift actuator I can now get into diagnostics, but when I try to do the recalibration procedure everything shuts off the second I press the start...2 replies 81 views
-
Before you hurry and tell me that I should be using pressure treated wood, please read this entirely, and carefully. I am a bee keeper, and I build "bee houses" which I mount on the exterior walls of my house. The boxes/houses I mount are approximately 3 feet long, 1 foot tall, and 1 foot wide...22 replies 154 views
-
Daughter is having current gas water heater with 4” galv ducting through roof (it is in basement of two story home with attic) replaced. How should the old vent and chase be decommissioned? Does installer typically do that? New one will go through side wall.2 replies 49 views